Brodit ProClip 532355 Active holder Tablet/UMPC Black

Car Active holder. Mobile device type: Tablet/UMPC. Built-in charger. Black. Active holder for fixed installation. Slim design with charger integrated in the holder. Fits unit both with and without handstrap.. Use an active holder for your Motorola ET1 while driving and you will always have a freshly charged battery! The holder provides a neat and comfortable installation -safe and convenient.. It is easy to put the unit into place in the holder, and to take it with you when leaving the car. The holder fits with units both with and without handstrap.. Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.. An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.. INSTALLATION INSTRUCTIONS:. Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.. Installation of the holder: 1. Place the holder onto the desired position. Screw the holder into place with the enclosed screws.. 2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder.. 3. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.. 4. The holder is in place.. Design. Compatibility. Motorola ET1. Connectivity technology. Wired. Material. Plastic. Product colour. Black. Type. Active holder. Proper use. Car. Mobile device type. Tablet/UMPC. Multimedia. Built-in speaker(s). No. Power. Power source type. Cigar lighter. Built-in charger. Yes

Price: £122.99 from Back to the Office