Self-guiding chamfer/bevel cutter. Bearing follows the board beneath. Dimensions: Cutting Length: 12.7mm Bearing Diameter: 9.5mm Angle: 45 degrees Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue do...
This cove style cutter with two flutes, give radiused grooves for decorative panel finishes and board edges. For deep channels, take a series of passes. Dimensions: Diameter: 25.4mm Cutting Length: 15.9mm Cutting Radius: 12.7mm ...
Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with. The guide bearing follows the vertical edge or template. Dimensions: Cutting Length: 14.3mm Bearing Diameter: 9.5mm Cutting Radius: 9.5mm
Self-guiding cutter for rounding over edges, without the need for a side fence. If cutter is lowered, a top quirk can be produced. Bullnose mouldings can also be produced by taking a second pass from the opposite side of the workpiece. D...
Self-guiding cutter for rounding over edges, without the need for a side fence. If cutter is lowered, a top quirk can be produced. Bullnose mouldings can also be produced by taking a second pass from the opposite side of the workpiece. D...
Self-guiding cutter for producing ovolo mouldings, without the need for a side fence. Top quirk can be removed by raising the cutter. Dimensions: Cutting Length: 15.9mm Bearing Diameter: 9.5mm Cutting Radius: 9.5mm Shank Diamete...
Self-guiding cutter for producing ovolo mouldings, without the need for a side fence. Top quirk can be removed by raising the cutter. Dimensions: Cutting Length: 19.1mm Bearing Diameter: 9.5mm Cutting Radius: 12.7mm Shank Diamet...
By raising the cutter, the top quirk is removed. Dimensions: Cutting Length: 15.9mm Bearing Diameter: 9.5mm Cutting Radius: 4mm Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue download, if shown below...
A small beading cutter for fine decorative panelling, veining or rounding over. Dimensions: Diameter: 9.5mm Cutting Length: 7.9mm Cutting Radius: 3.2mm Shank Diameter: 1/4 inch Please note that prices in the Trend Catalogue ...
A self guiding flat ovolo to give a smooth corner finish. Alternatively, can be used to produce glazing bar profiles. Dimensions: Cutting Length: 11mm Bearing Diameter: 9.5mm Rebate: 10.2mm Cutting Radius: 12mm Shank Diameter...
|
|