One flute. Eccentric single flute cutter. Cutter is chosen for fast free cutting, when cutting speed takes preference over finish. Must not be used in eccentric chucks. This cutter has a Solid Carbide insert rather than brazed tip.
This cutter simplifies the construction of framing. The ogee matches the scriber 20/20X1/4TC to form a corner joint. Tenon and groove/rebate must be cut separately. Classic style for moulding, panelling and jointing. Make joints with Refs...
This cutter simplifies the construction of framing. The scriber matches the ogee 20/3X1/4TC to form a corner joint. Tenon and groove/rebate must be cut separately. Dimensions: Diameter: 28.5mm Cutting Length: 16.5mm Cutting Radi...
Complete with one bearing. Dimensions: Diameter: 38.1mm Cutting Length: 16mm Bearing Diameter: 38.1mm Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue download, if shown below, may differ to the websit...
Edge moulds of classic proportions. Used to obtain decorative channels. Dimensions: Diameter: 26mm Cutting Length 1: 6mm Cutting Length 2: 10mm Cutting Radius 1: 2mm Cutting Radius 2: 6mm Shank Diameter: 1/4 inch Ple...
Decorative cavetto cutter for raised panelling or edge moulding. Dimensions: Diameter: 22mm Cutting Length: 11mm Cutting Radius: 10mm Shank Diameter: 1/4 inch Please note that prices in the Trend Catalogue download, if shown...
Complete with one bearing. Dimensions: Diameter: 19.1mm Cutting Length: 16mm Bearing Diameter: 19.1mm Cutting Radius: 6.35mm Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue download, if shown below...
Primarily water channel cutter. Also produces radiused rebates and grooves. Suitable for plunge cutting. Dimensions: Diameter: 16 mm Cutting Length: 25 mm Cutting Radius: 5 mm Shank Diameter: 1/2 inch Please note that prices...
The shank mounted bearing is used to accurately guide the set for cove mouldings. The three end mounted bearings are interchanged to vary the lower quirk on the ovolo moulds. Can be used portably or in a router table. Dimensions: "Dia...
Oversize profiler allows component to be routed oversize to template. Useful when making jigs, templates and patterns. Can be used for trenching operations in shallow passes. Dimensions: Diameter: 8mm Cutting Length: 19mm Rebate...
|
|