Replacement bearing for router cutter. Always check the tightness of the fixing screw before using the cutter. Ball bearings should be wiped clean, not dipped in solvent. Prevent resin build-up by cleaning with wire brush. Dimensions:...
Right handle for the T10 router. Please note that prices in the Trend Catalogue download, if shown below, may differ to the website prices, as those listed in the Catalogue are Trend List Prices excluding VAT....
Two fluted tungsten carbide weatherseal groover for use on natural timbers and manmade boards. The cutter is Teflon cutted to reduce resin build up. Neatly cuts grooves on doors or frames to accept a weattherseal. Dimensions: Diameter=36...
For stationary machines or portable routers mounted in a table. Fixed head use, maximum 18000 rpm. Dimensions: Diameter=50 mm Cutting Radius 1: 12 mm Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue do...
Please note. This tool should not be resharpened. Thickness Min. 8mm - Max. 12mm. For stationary machines at 24000 RPM. Dimensions: Diameter=42 mm Cutting Length 1: 12 mm Angle: 45 degrees Shank Diameter: 1/4 inch Plea...
Ideal for engraving and veining work. Use on timber and man made boards. Dimensions: Diameter=1/2 inch Diameter=12.7 mm Cutting Length: 11 mm Overall Length: 45 mm Angle: 45 degrees Shank Diameter: 1/4 inch Please n...
Flat Roman Ogee, for raised panelling or edge moulding. Used for decorative capping on hand rails. For stationary machines - 18000 RPM recommended speed. Dimensions: Diameter=50 mm Cutting Length 1: 6.5; Cutting Length 2: 11.5 mm C...
Two fluted Tungsten Carbide Tipped straight cutters. Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Has a bottom cut feature....
A bearing guided round over & ovolo router cutter supplied with three ball bearings to give a rounding over and two sizes of step ovolo mould on timber. Round over effect with largest bearing. Ovolo with 1.6mm (1/16+) step/quirk using 1/2+ bearing...
Two fluted Solid Carbide insert straight cutters. Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Has a bottom cut feature.
|
|