Bahco FM10 Filemaster with an ERGO™ handle suitable for use on ferrous and non-ferrous metals, plastics, laminates and hard woods. The parallel file FM10 has milled teeth (one side shear cut the other curved teeth). Size: 250mm (10in)...
For sharpening circular, felling and gang saws with fine toothing and also used on bandsaw. Excellent for draw and fine filing, polishing and deburring work. Often used in the engineering industry for lathe, deburring or draw filing.
Set of 12 needle files in snapshut plastic wallet with hanging hole. One of each of the following : Hand, flat, half round, round, three square, square, crossing, knife, barrette, slitting, round edge joint and marking files, with han...
Bahco Half Round Cut File with a tapered half round cross section to allow use on convex and concave surfaces. The edges and surfaces are tapered towards the point. It has a double cut surface, and it suitable for deburring work. Smooth Cut...
Bahco Second Cut Round Rasp for work on plywood, wallboard, plastics and other soft materials. The comfortable ERGO™ handle gives good grip and control. Size: 200mm (8in). ...
A Bahco Handle for Flat and Half Round Files that features a two component ERGO™ design. The end covers the tang and shoulder of the file for safety and comfort. ...
Bahco Half Round Cut File with a tapered half round cross section to allow use on convex and concave surfaces. The edges and surfaces are tapered towards the point. It has a double cut surface, and it suitable for deburring work. Smooth Cut...
Bahco Taper Saw File has a triangular shape, with edges tapering towards the point. The surfaces and edges single cut. For sharpening saws with cross toothing at a 60° angle. It is also tanged. Available only in second cut. Size...
Smooth single cut teeth for sharpening round hooded chain saw teeth. Safe point and special tooth construction for rapid cutting. Length 150mm (6in). Diameter (1/8in). ...
Bahco Flat files do the same jobs as hand files but are sometimes preferred because the tapered shape enables the user to reach into angles and corners more easily. Slightly tapered in width and thickness. Suitable for general work on iron ...
|
|