Bosch tacker nails made of hard steel wire with lengths between 16 and 30 mm Width of head depending on machine 1.8 or 2.8 mm Appropriate for tackers from AEG, Bosch, Esco, Kwb, Lux, Mekano, Metabo, Novus, Peugeot, Rocafix, Rocagraf, St...
Bosch tacker nails made of hard steel wire with lengths between 16 and 30 mm Width of head depending on machine 1.8 or 2.8 mm Appropriate for tackers from AEG, Bosch, Esco, Kwb, Lux, Mekano, Metabo, Novus, Peugeot, Rocafix, Rocagraf, St...
Stanley SharpShooter Type G heavy-duty staples. Also known as Type: 4 or 11 or 140. Fits Stanley: 69-809, TR60, TR100 series, TR200 series, TRE500 series, PHT150 and G11. STA1TRA705T Heavy-Duty Staples have the following specific...
These staples are for use with the Arrow HT30 Hammer Tacker. Size: 8mm Box Quantity 5000. ...
BT Series galvanised 18 gauge Brad fasteners for use with the Bostitch Finish Bradders. Joined with an adhesive coating that holds the brads together. Finish nails (Brads) are normally of a rectangular cross section instead of being round. ...
Finish Nails have heads that are rectangular. They are the same width as the shank, but the breadth of them is greater than the shank. This ensures that their holding power is enhanced, but of course the pull through force is lower than for nails ...
Packs of 2000 Round head nails. These plastic collated stick nails traditionally have a full round head, while only giving marginally better holding power to clipped head nails, they are preferred by the construction industry. Collation is a...
Finish Nails have heads that are rectangular. They are the same width as the shank, but the breadth of them is greater than the shank. This ensures that their holding power is enhanced, but of course the pull through force is lower than for nails ...
Stick Nails for use with the Stanley Bostitch Wire Weld Framing Nailers, the traditional wire weld collation gives the stick nails more rigidity and resistence to damp environments. 28° Collation Angle Designed for the constructi...
Finish Nails have heads that are rectangular. They are the same width as the shank, but the breadth of them is greater than the shank. This ensures that their holding power is enhanced, but of course the pull through force is lower than for nails ...
|
|