Has 2 lips, 2spurs and a centre brad point. Flutings are backed-off to give a radial relief and assist chip clearance. This drill is used mainly for drilling cross grained timber and particle board. Used in all branches of industry when clea...
This lip and spur dowel drill features Solid Carbide cutting tips, for continuous drilling of tear free dowel holes. Shank has one flat for positive holding. A threaded grub screw in the shank end allows for correct setting for a bank of drills...
This 60 degree taper multi-boring drill is ideal for end grain and through hole drilling applications. Reduces the likelihood of +break out+ to a minimum. Drill has a Solid Carbide cutting tip. Shank has one flat for positive holding. A t...
This 60 degree taper multi-boring drill is ideal for end grain and through hole drilling applications. Reduces the likelihood of +break out+ to a minimum. Drill has a Solid Carbide cutting tip. Shank has one flat for positive holding. A t...
This 60 degree taper multi-boring drill is ideal for end grain and through hole drilling applications. Reduces the likelihood of +break out+ to a minimum. Drill has a Solid Carbide cutting tip. Shank has one flat for positive holding. A t...
This 60 degree taper multi-boring drill is ideal for end grain and through hole drilling applications. Reduces the likelihood of +break out+ to a minimum. Drill has a Solid Carbide cutting tip. Shank has one flat for positive holding. A t...
Trend Rose C´Sink 12.5mm C´Sink Dia (Hss Drilling Tools / Rose 90 Degree Countersinks) This countersink is produced in HSS and should not be confused with carbon steel types. Designed for countersinking mild steel, iron and plastics.
This slow spiral TCT drill can be used in drilling machines or plunge routers. Use between 1000 and 22000 RPM. Dimensions: Diameter: 5mm Overall Length: 57mm Shank Diameter: 1/4 inch Please note that prices in the Trend Cata...
This countersink is produced from the best grade carbon steel, leaves a clean cut finish by virtue of their multi-tooth deep ground gullets. For use with fast spiral drills. Fits metric drills from 3mm to 12mm inclusive. Drill bit not includ...
This countersink is produced from the best grade carbon steel, leaves a clean cut finish by virtue of their multi-tooth deep ground gullets. For use with fast spiral drills. Fits metric drills from 3mm to 12mm inclusive. Drill bit not includ...
|
|