This machine bit is designed for recessing circular concealed hinges. The shank has a flat for securing and a grub screw for height adjustment. Use at recommended speeds of 10000RPM. Dimensions: Diameter: 25mm Overall Length: 57mm<...
For coves and part of a rule joint. Solid Carbide insert. Dimensions: Diameter: 6.4 mm Cutting Length: 7/16 inch Cutting Length: 12.7 mm Cutting Radius: 3.2 mm Shank Diameter: 1/4 inch Please note that prices in the T...
For coves and part of a rule joint. Single flute. Dimensions: Diameter: 12.7mm Cutting Length: 19mm Cutting Radius: 6.3mm Shank Diameter: 8mm Please note that prices in the Trend Catalogue download, if shown below, may d...
For coves and part of a rule joint. Two flute. Dimensions: Diameter: 19.1mm Cutting Length: 31.7mm Cutting Radius: 9.5mm Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue download, if shown below, m...
For coves and part of a rule joint. Two flute. Dimensions: Diameter: 18mm Cutting Length: 19mm Cutting Radius: 9mm Shank Diameter: 1/4 inch Please note that prices in the Trend Catalogue download, if shown below, may dif...
Tungsten Carbide Tipped. Two flute cutter with tip sheared up and down, giving a fine finish. For trimming veneered and double-faced boards, plywoods and natural timbers. Action of pushing the chips towards the middle of the board being cut....
Decorative panel mould cutter for raised panelling or edge moulding. Dimensions: Diameter: 25mm Diameter: 10mm Cutting Length: 9.5mm Cutting Radius: 3.2mm Shank Diameter: 1/4 inch Please note that prices in the Trend Cata...
This Raised Panel cutter runs best at lower speeds between 12,000 and 18,000 RPM. Matches our range of profile scribers. Suitable for use on natural timber and MDF. When joining sections to produce solid wood panels, alternate the growth r...
Decorative classic panel mould cutter for raised panelling or edge moulding. Dimensions: Diameter: 19mm Cutting Length: 12.7mm Cutting Radius 1: 4mm Cutting Radius 2: 5mm Shank Diameter: 1/4 inch Please note that prices i...
Ideal for following templates for panelling and profiling in furniture manufacture. It is advisable that the template is at least 5mm thicker than the cut length of the cutter. Complete with one bearing. Dimensions: Diameter: 22mm ...
|
|