Thumb knob spring for the T10 router. Please note that prices in the Trend Catalogue download, if shown below, may differ to the website prices, as those listed in the Catalogue are Trend List Prices excluding VAT....
Power socket for the T11ELK router. Dimensions: 115 VOLT Please note that prices in the Trend Catalogue download, if shown below, may differ to the website prices, as those listed in the Catalogue are Trend List Prices excluding VAT....
Designed to accommodate the Schlegel Aquamac 63 weather strip system. Allows for a particularly small gap between sash and frame. The slot can be positioned part way down the side of the rebate, or at the bottom of the rebate. The Recessin...
Two fluted Solid Carbide insert straight cutters. Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Has a bottom cut feature.
Attractive edge moulds. A full corner bead can be produced by making a second pass at 90 degrees. Dimensions: Diameter=31.9 mm Cutting Radius 1: 7 mm Shank Diameter: 1/4 inch Please note that prices in the Trend Catalogue d...
Two fluted Solid Carbide insert straight cutters. Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Has a bottom cut feature.
Can be used with radius cutters, to make rule joints. Dimensions: Diameter=38 mm Cutting Length: 18 mm Cutting Radius: 12.7 mm Shank Diameter: 1/2 inch Please note that prices in the Trend Catalogue download, if shown below,...
Switch for the T10 router. Please note that prices in the Trend Catalogue download, if shown below, may differ to the website prices, as those listed in the Catalogue are Trend List Prices excluding VAT....
A two flute 22.5 degree bevel cutter for routing eight sided stave box. Dimensions: Diameter=28 mm D2=4.82 mm Cutting Length: 28 mm Overall Length: 68 mm Angle: 67.5 degrees Shank Diameter: 1/4 inch Please note that pr...
Replacement bearing for router cutter. Always check the tightness of the fixing screw before using the cutter. Ball bearings should be wiped clean, not dipped in solvent. Prevent resin build-up by cleaning with wire brush. Dimensions:...
|
|