To rout butterfly key and splines in timbers and man-made boards. Use in conjunction with 104 deg (14 deg) dovetail cutter ref. L120 which cuts dovetail pocket. Use in a router table. Cut material in two passes to create a butterfly shape, width of...
The classic method of producing cabinet panelled door and drawer fronts is made easy with these Profile Scriber sets. With the combination type, components are re-arranged on the arbor to cut the profile or the scribe. Cuts both parts of the joint by...
These machine bits have two wings, two scribers and a centre point. Tungsten carbide tipped for extensive drilling of particle boards, and plastics of soft to medium density. The scribe gives a very clean entrance hole. Not for use on hard dense materials...
Ideal for hiding pipes and cables. Part of curve can be used for producing decorative edges. An initial slot is required before using the ball groovers. Specifications • Shank Diameter: 1/2 • Dia Metric: 12.7 • Dia2 Metric: 6.5 •...
Cut a wider edge line, at an angle of 80 degrees. A 16mm bearing is supplied as standard. A larger 19mm bearing will spread the wear of the cutting edges. Specifications • Shank Diameter: 1/4 • Dia Metric: 20 • Cut Length Metric: 14...
Used to slot and trim low melting point plastics such as ABS, Styrene and PVC. For maximum life these cutters are Solid Carbide. Two flute for fine finish. Specifications • Shank Diameter: 1/4 • Dia Metric: 6.3 • Dia Imperial: 1/4...
Cuts out apertures in laminate worktops. The nose of the cutter acts as a guide follower. Specifications • Shank Diameter: 8 mm • Dia Metric: 6.3 • Dia Imperial: 1/4 • Cut Length Metric: 18 • Cut Length Imperial: 45/64 •...
Machining of traditional panels and frame doors, formerly done on spindle moulders, can now be performed with heavy duty routers mounted in fixed positions, either overhead or inverted. These Raised Panel cutters run best at lower speeds and match our...
A quarter ellipse cutter for architraves and hand rails. Can be used to form the top portion of handrail moulding when used in conjunction with Ref. 93/3. Specifications • Shank Diameter: 1/2 • Dia Metric: 69.2 • Cut Length Metric:...
Four fluted TCT trimmer/profiler. Super fine finish. Ball bearings fitted to both nose and shank. Allows templates to be placed either on top or the bottom of the material, for ease of routing. Allows for irregular grained timber to be profiled...
|
|