Flat Roman Ogee, for raised panelling or edge moulding. Used for decorative capping on hand rails. Specifications • Shank Diameter: 1/2 • Dia Metric: 50 • Cut Length Metric: 6.5 • Overall Length Metric: 51.8 • Radius 1 Metric:...
Use for bevelling, chamfering and for producing mortar grooves. Approximately 1.0mm flat will be found on the nose. Specifications • Shank Diameter: 1/4 • Dia Metric: 12.7 • Dia Imperial: 1/2 • Cut Length Metric: 10.3 • Overall...
Trend biscuits are made of die cut beech. Beechwood biscuits which expand when in contact with a woodworking adhesive such as PVA glue. They are ideal for strong, fast, and accurate jointing of hard and soft woods, plywood and composition board. ...
To produce an undercut on relief lettering to create a more aesthetic appearance, as well as for edge grooving. Specifications • Shank Diameter: 1/4 • Dia Metric: 19.1 • Dia Imperial: 3/4 • Cut Length Metric: 3.2 • Cut Length...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Template thickness should be 5mm thicker than cut length of cutter. Can be used to rout both tenons and housings. Specifications • Shank Diameter: 1/4 • Dia Metric: 19.1 • Dia Imperial: 3/4 • Cut Length Metric: 11.1 • Overall...
By raising the cutter, the top quirk is removed. Alternative bearing Refs. B95A & B127A. Specifications • Shank Diameter: 1/4 • Dia Metric: 34.9 • Cut Length Metric: 13.5 • Overall Length Metric: 65 • Bearing Dia Metric: 12.7...
Versatile cutter, using all or part of the cutter. Specifications • Shank Diameter: 1/4 • Cut Length Metric: 15.9 • Cut Length Imperial: 5/8 • Overall Length Metric: 65.5 • Bearing Dia Metric: 9.5 • Bearing Dia Imperial:...
Single fluted Tungsten Carbide straight cutter for fast free cutting. Single flutes should be chosen where speed and clearance rates are more important than the finish. Depth of cut should not exceed cutter diameter. Specifications • Shank Diameter:...
Larger bearing removes the flat. Supplied with two bearings. Specifications • Shank Diameter: 1/2 • Dia Metric: 41 • Cut Length Metric: 13 • Overall Length Metric: 62 • Bearing Dia Metric: 12.7 • Bearing Dia Imperial:...
|
|