DeWalt's Flexvolt Landscaping range was developed as a user friendly alternative to petrol power - with no hazardous fuel to transport and store, no fumes, less mess and less noise, these tools are much more convenient for the end user as well as more...
2.0mm twisted line designed for DeWalt cordless grass trimmers and brush cutters.
Operating on powerful 54v Flexvolt batteries, the DCM571 is designed for fast and effective job completion, whether trimming grass or clearing overgrown areas. It includes a brush cutter blade and a line spool. A cutting swath of 38cm enables fast job...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Creates a corner bead with a step. By making a second pass at 90 degrees a full corner bead can be cut. Two flutes give a clean finish to cut edges. Specifications • Shank Diameter: 1/4 • Dia Metric: 22 • Dia2 Metric: 18.9 • Overall...
Tri wing brush cutter blades are ideal for clearing tough, matted grass and thick clusters of weeds. The DT20653 Tri Wing blade is designed for use with the DeWalt DCM571 Flexvolt cordless brush cutter.
Self-guiding cutters for rounding over edges do not require a side fence. They are supplied with two bearings. Use the larger bearing for a round-over. If the cutter is lowered, a top quirk can be produced. A full round/bullnose for stair treads...
Low kickback and low vibration chain for the DeWalt DCM575 Flexvolt cordless chainsaw. Features and Benefits • Genuine replacement chain for the DeWalt DCM575 • Low Kickback • Low Vibration Specifications • Bar Length: 400mm •...
Supplied with extra 1/2 inch bearing for removing the lower quirk. Specifications • Shank Diameter: 1/4 • Cut Length Metric: 17.5 • Cut Length Imperial: 11/16 • Overall Length Metric: 69 • Bearing Dia Metric: 9.5 • Bearing...
A one piece set. Parts are inter-changed on the arbor to alter the set-up. For use with router table only. Specifications • Shank Diameter: 8 mm • Dia Metric: 41 • Cut Length Metric: 6.35 • Overall Length Metric: 75 • Bearing...
|
|