Self guided with low profile ball bearing guide and bearing fixing screw. For use in restrictive applications or within rebates of minimum 8mm. Down cut to prevent breakout on veneers. Specifications • Shank Diameter: 1/4 • Dia Metric:...
A popular variety, the Modern Torus skirting board mould. Specifications • Shank Diameter: 1/2 • Dia Metric: 35 • Dia Imperial: 1 3/8 • Cut Length Metric: 39 • Overall Length Metric: 88 • Bearing Dia Metric: 16 • Radius...
Straight two flute for drilling and slotting, cutting aluminium anodised duralium and uPVC plastic. Cutters are designed to plunge and machine or mill lateral slots. All aluminium tooling should be used with a coolant, wax stick or lubricant. Ideal...
The two bearings supplied offer the means of cutting different depths of mouldings. Specifications • Shank Diameter: 1/2 • Dia Metric: 34.9 • Cut Length Metric: 16 • Overall Length Metric: 64 • Bearing Dia Metric: 9.5 •...
Used for trimming plastic or plywood overlays. Also for copy profiling with a template. Specifications • Shank Diameter: 1/2 • Dia Metric: 19.1 • Dia Imperial: 3/4 • Cut Length Metric: 50 • Overall Length Metric: 102 •...
These specially designed machine bits have a specially designed form of scriber to allow use at high speeds. For recessing circular hinges. For accurate repetitive routing, a template and guide bush fitted to the router base should be used. Specifications...
Self-guiding cutters for rounding over edges do not require a side fence. They are supplied with two bearings. Use the larger bearing for a round-over. If the cutter is lowered, a top quirk can be produced. Bullnose mouldings can also be produced...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Produces an elegant edge mould, or a shallow panel effect when routing on its full width. Specifications • Shank Diameter: 1/2 • Dia Metric: 20 • Cut Length Metric: 15 • Overall Length Metric: 53 • Radius 1 Metric: 6
To create profiles on face or edge of drawer fronts and cabinet doors. Specifications • Shank Diameter: 1/4 • Dia Metric: 19.1 • Dia Imperial: 3/4 • Cut Length Metric: 14 • Cut Length Imperial: 35/64 • Overall Length Metric:...
|
|