TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/2 • Dia Metric: 21 • Dia Imperial:...
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. TC tips are ground with greater clearance for routing of resinous material. Specifications...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with. The guide bearing follows the vertical edge or template. Alternative bearing Ref. B127A creates a shallow radius. Specifications • Shank Diameter: 1/2 •...
Eccentric single flute cutters. Cutters are chosen for fast free cutting, when cutting speed takes preference over finish. Cutters with prefix S are Solid Carbide. Cutters of 2.0mm diameter and below should have a maximum of 1.0mm depth of cut per...
High performance multi-material long life Zirconium abrasive for 125mm Diameter Random Orbit Sanders. Suitable for wood, paint, plaster and metal SUPERIOR DUST EXTRACTION Elongated hole pattern ensures base compatibility and aids maximum extraction capability...
Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Cutter has a bottom cut feature. Specifications • Shank Diameter: 1/2 • Dia...
Self-guiding cutters for rounding over edges do not require a side fence. They are supplied with two bearings. Use the larger bearing for a round-over. If the cutter is lowered, a top quirk can be produced. A full round/bullnose for stair treads...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Profiler with shank mounted bearing guides. For use with router mounted above or below a table when following a template. For profiling and rebating applications only. Not for plunge cutting/grooving. A 3mm maximum overlap should be left before...
|
|