Four fluted cutter for routing tenons with a clean finish on the shoulder. Tungsten Carbide Tipped for use on timber and abrasive man-made boards. Cutter has four cutting edges with two down-shear blades for the shoulder and two up-shear for the face...
Self-guiding cutters with the facility to change the profile by fitting a larger bearing & varying the depth. Supplied with two bearings. The larger bearing removes the bottom quirk. Specifications • Shank Diameter: 1/2 • Dia Metric: 51...
With bearing guided ogees, change profile by using a larger bearing and vary the depth. Specifications • Shank Diameter: 1/2 • Dia Metric: 25.4 • Dia Imperial: 1 • Cut Length Metric: 15.9 • Cut Length Imperial: 5/8 • Overall...
Self-guiding cutters for rounding over edges do not require a side fence. They are supplied with two bearings. Use the larger bearing for a round-over. If the cutter is lowered, a top quirk can be produced. A full round/bullnose for stair treads...
Template thickness should be at least 5mm thicker than cutter cut length of cutter. Approximately 1.0mm flat will be found on the nose. Specifications • Shank Diameter: 1/4 • Dia Metric: 12.7 • Dia Imperial: 1/2 • Cut Length Metric:...
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/2 • Dia Metric: 15.9 • Dia Imperial:...
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/2 • Dia Metric: 16 • Dia Imperial:...
This Raised Panel cutter runs best at lower speeds between 12,000 and 18,000 RPM. Matches our range of profile scribers. Suitable for use on natural timber and MDF. When joining sections to produce solid wood panels, alternate the growth ring direction...
Specially designed tools for aluminium composite cladding material such as Alucobond, Dibond which comprises an aluminium cover with polyethylene core. The v groove cutters rout into the cover and part of the core to allow folding of material by hand....
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Specifications • Shank Diameter: 1/4 • Dia Metric: 8 • Dia Imperial: 5/16 • Cut Length Metric:...
|
|