TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/2 • Dia Metric: 14 • Dia Imperial:...
Panel raiser cutters for producing the panel for cabinet panelled doors, tool matches our range of profile scribers. Suitable for use on natural timber and MDF. For use in a router table only. Take several passes, increasing the depth with each pass....
Self guided tools for trimming inlay or overlaps. Specifications • Shank Diameter: 1/2 • Dia Metric: 28.6 • Dia Imperial: 1 1/8 • Cut Length Metric: 38.1 • Cut Length Imperial: 1 1/2 • Overall Length Metric: 92 • Bearing...
A bearing guided reversible finger jointer, to increase the gluing area for edge to edge joints. Specifications • Shank Diameter: 1/4 • Dia Metric: 24.6 • Cut Length Metric: 18.5 • Overall Length Metric: 58 • Bearing Dia Metric:...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Popular rebate sets which include different size bearings for a choice of rebates. Ease of setting-up and accurate depth of cut. Ideal for rebating straight and shaped work pieces. Has a 60mm shank length to give access to deep rebates. When using bearing...
Profiler with shank mounted bearing guides. For use with router mounted above or below a table when following a template. For profiling and rebating applications only. Not for plunge cutting/grooving. A 3mm maximum overlap should be left before...
By raising the cutter, the top quirk is removed. Specifications • Shank Diameter: 1/2 • Dia Metric: 25.4 • Cut Length Metric: 15.9 • Cut Length Imperial: 5/8 • Overall Length Metric: 63.5 • Bearing Dia Metric: 9.5 •...
Two fluted tungsten carbide weatherseal groover for use on natural timbers and manmade boards. The cutter is non stick coated to reduce resin build up. Neatly cuts grooves on doors or frames to accept a weatherseal. Specifications • Shank Diameter:...
The CB counterbores are extensively used for recessing bolt and screw heads. Supplied with a HSS slow spiral drill bit. Fully adjustable, a hex key is supplied. TCT version is used for plywood, particle boards and plastics (abrasive). Use a drilling speeds...
|
|