This 'roughing' trimmer, leaves an overhang of 3mm, for secondary final trim. Specifications • Shank Diameter: 1/4 • Dia Metric: 12.7 • Dia Imperial: 1/2 • Cut Length Metric: 25.4 • Cut Length Imperial: 1 • Overall Length...
Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Cutter has a bottom cut feature. Specifications • Shank Diameter: 8 mm • Dia...
These are ideal for engraving and decorative panel work. Made with Solid Tungsten Carbide inserts, with two flutes. Specifications • Shank Diameter: 1/4 • Dia Metric: 4.8 • Dia Imperial: 3/16 • Cut Length Metric: 12.7 • Cut...
They are designed to drill and coutersink simultaneously, a wide variety of materials. Supplied with a HSS slow spiral drill bit. Fully adjustable, a hex key is supplied. The TCT version is used for plywood, particle boards and plastics (abrasive)....
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Gives a narrow appearance to a board edge. Specifications • Shank Diameter: 1/4 • Dia Metric: 22 • Cut Length Metric: 10 • Overall Length Metric: 39 • Radius 1 Metric: 3
Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with. The guide bearing follows the vertical edge or template. Alternative bearing Ref. B127A creates a shallow radius. Specifications • Shank Diameter: 1/4 •...
Self guided for modern architrave & skirting. Specifications • Shank Diameter: 8 mm • Dia Metric: 40 • Cut Length Metric: 29.5 • Overall Length Metric: 74.3 • Bearing Dia Metric: 9.5 • Radius 1 Metric: 9 • Angle: 73
These slotters have a M12 threaded boss to enable them to be threaded onto the arbor without the need for a securing nut. Specifications • Dia Metric: 50 • Sawbore: M12 • Saw Kerf Metric: 7 • Saw Teeth: 4
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/4 • Dia Metric: 17 • Dia Imperial:...
|
|