Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Cutter has a bottom cut feature. Specifications • Shank Diameter: 8 mm • Dia...
The glazing bar ovolo cutter is bearing guided to speed setting-up and to enable curved frames to be moulded. Specifications • Shank Diameter: 1/4 • Dia Metric: 27 • Cut Length Metric: 17 • Overall Length Metric: 56.1 • Bearing...
Panel raiser cutters for producing the panel for cabinet panelled doors, tool matches our range of profile scribers. Suitable for use on natural timber and MDF. For use in a router table only. Take several passes, increasing the depth with each pass....
Self-guiding cutters for rounding over edges do not require a side fence. They are supplied with two bearings. Use the larger bearing for a round-over. If the cutter is lowered, a top quirk can be produced. A full round/bullnose for stair treads...
Ideal for newel posts and caps for stairs. Supplied with one bearing. Specifications • Shank Diameter: 1/4 • Dia Metric: 35.1 • Cut Length Metric: 12 • Overall Length Metric: 57 • Bearing Dia Metric: 12.7 • Bearing Dia...
Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check...
Extra long two flute cutter for routing hollow honey-comb work top boards only. Use only in professional routers with an 80mm deep plunge and suitable one piece multi-slit collet to ensure safe cutter retraction into the router base. TC tips are conventionally...
Two flute TC cutter giving good chip clearance. Ideal for shallow lateral routing cuts such as recessing hinges. Corners will require final trimming square with a hand chisel or a corner chisel. Specifications • Shank Diameter: 1/4 • Dia...
Self-guiding cutters for rounding over edges do not require a side fence. They are supplied with two bearings. Use the larger bearing for a round-over. If the cutter is lowered, a top quirk can be produced. A full round/bullnose for stair treads...
Purpose made for stair housing jigs. Ensures tight fit of tread in string. Specifications • Shank Diameter: 1/2 • Dia Metric: 22 • Dia Imperial: 7/8 • Cut Length Metric: 26 • Cut Length Imperial: 1 • Overall Length Metric:...
|
|