TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/2 • Dia Metric: 19.1 • Dia Imperial:...
Four fluted TCT trimmer/profiler. Super fine finish. Ball bearings fitted to both nose and shank. Allows templates to be placed either on top or the bottom of the material, for ease of routing. Allows for irregular grained timber to be profiled...
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/4 • Dia Metric: 16 • Dia Imperial:...
These machine bits have two wings, two scribers and a centre point. Tungsten carbide tipped for extensive drilling of particle boards, and plastics of soft to medium density. The scribe gives a very clean entrance hole. Not for use on hard dense materials...
Ideally suited for cutting radiused edges at speed, as a side fence can be dispensed with. The guide bearing follows the vertical edge or template. Alternative bearing Ref. B127A creates a shallow radius. Specifications • Shank Diameter: 1/4 •...
Alternative bearing B127A removes the lower quirk. Specifications • Shank Diameter: 1/4 • Dia Metric: 34.9 • Cut Length Metric: 17.5 • Cut Length Imperial: 11/16 • Overall Length Metric: 69 • Bearing Dia Metric: 9.5 •...
TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics. Two flutes give a clean finish to cut edges. Has a TCT plunge centre tip. Specifications • Shank Diameter: 1/2 • Dia Metric: 50 • Dia Imperial:...
Single flute helical for drilling and slotting, cutting aluminium anodised duralium and uPVC plastic. Cutters are designed to plunge and machine or mill lateral slots. All aluminium tooling should be used with a coolant, wax stick or lubricant. ...
Use for bevelling, chamfering and for producing mortar grooves. Approximately 1.0mm flat will be found on the nose. Is ideal for imitating 'V' jointed tongue and groove on man-made board. Specifications • Shank Diameter: 1/2 • Dia Metric:...
This double ribbed ovolo style is an alternative to the rounding over cutter. If the cutter is lowered, a top quirk can be produced. Specifications • Shank Diameter: 1/4 • Dia Metric: 28.7 • Cut Length Metric: 12.7 • Cut Length Imperial:...
|
|