This set incorporates two drill countersinks and matching plug cutters. Plugs cutters are made from Tool Steel and are very slightly tapered. Use on timber to drill a countersunk hole for a screw which is then plugged uses a plug/pellet made using the...
The ITL Totally Insulated Open End Spanners offer maximum personal protection as the entire tool is insulated. They are made from injection moulded nylon 11 which exceeds the requirements of IEC 60900, the industry standard for live line working. In addition,...
Trend Snappy Standard Plug Cutter - 12.7mm Diameter Made from Tool Steel for durable performance in hard and softwoods. Fast cutting four prong design. Plugs easily snap out using a screwdriver. Cuts tapered plugs that tighten as they are driven for...
The ITL Insulated Combination Pliers with side cutter and injection moulded nylon 11 handles, which exceed the requirements of IEC 60900, the industry standard for live line working. In addition, this tool meets the requirements of Category 'C', which...
Quick release 1/4 inch hex shank for use in quick tool change drills. Accurate self centred pilot hole drilling for hinges and lock face plates. Use on timbers and boards. High Speed Steel (HSS) drlll bit for longer life. Sprung loaded to ensure drill...
Trend Craft Pro saw blade - 165mm diameter 20mm bore 48tooth TCT Specialist blade with -6 degree hook, 2mm kerf with 1.8mm plate thickness for clean, safe cutting of plastics and alloys with plunge saws. TCP (Triple Chip Profile) tungsten carbide...
Trend Snappy 9.5mm diameter countersink - with adjustable drill 9.5mm diameter countersink with pilot drill designed for Imperial gauge screws. The perfect, fast swap accessory for clean, consistent finishes. Made from hardened tool steel for assured...
The ITL Totally Insulated Open End Spanners offer maximum personal protection as the entire tool is insulated. They are made from injection moulded nylon 11 which exceeds the requirements of IEC 60900, the industry standard for live line working. In addition,...
The ITL Insulated Phillips Screwdrivers produced with an injection moulded nylon 11 handle, which exceeds the requirements of IEC 60900, the industry standard for live line working. In addition, this tool meets the requirements of Category 'C', which...
The ITL Insulated Snipe Nose Pliers with side cutter and injection, moulded nylon 11 handles, which exceed the requirements of IEC 60900, the industry standard for live line working. In addition, this tool meets the requirements of Category 'C', which...
|
|